5
NOTE: DO NOT
attempt to install the insert from the front of the mantel - it will not fit.
STEP 2.
With the help of an adult assistant, lift the insert (E) carefully into the back of the mantel.
DO NOT
drag the unit across the mantel base or insert shelf, as it could scratch the wood surface.
From the front of the mantel, check to make sure the fireplace insert is properly aligned.
Thread three insert screws (D) through the holes at the top of the insert. Tighten each screw
securely with a screwdriver. DO NOT OVER-TIGHTEN.
Place the “L” bracket (G) in the center of the mantel base so it touches the back of the insert.
Thread two insert screws (D)
through the lower holes in the “L” bracket and into the mantel base.
Tighten the screws securely with a Phillips screwdriver. DO NOT OVER-TIGHTEN.
WARNING
This fireplace has wheels.
NEVER
use near
stairs
or
ramps
, or on
unlevel surfaces
. Doing so could cause the fireplace to
roll downhill
or
down stairs
, and cause
personal injury or property damage
.
REMOTE CONTROL
The remote control operates with one 3V CR2025
Lithium Cell Battery (included).
Remove the protective sheet between the battery and
the contacts in order to operate (see below).
Remote Control Set-up
Fig. 1:
Remove the plastic sheet from the end of the remote control to allow the battery to
touch the electrical contacts.
If the sheet is not removed, the remote control will not work.
Fig. 2
: To install or replace the battery, press the button to allow the battery case to slide out.
Position the battery according the drawing, and slide the case back in to the remote.
FIG 1
FIG 2
NEVER
dispose of batteries in
fire.
Failure to observe this precaution
may result in an
explosion
.
Dispose of batteries at your local hazardous material processing center.
ALWAYS
replace the battery in the remote control with the
same type of battery
.
Failure to do so may result in
personal injury
or
property damage
.
D
D
E
D
G