User
Manual
TEN 070
UNPACKING
Once packaging has been removed no damage must be evident. On the contrary, Service Centre must be
informed.
Disposal of packaging material will be carried out by customer in compliance with the regulations in force
in the country where the machine is used.
PRE-ARRANGEMENT TO BE CARRIED OUT BY CUSTOMER
The user installs machine in suitable rooms, equipped with electrical system in compliance with regulations in force.
Installation must be carried out in well-ventilated environments, dry and illuminated in compliance with current
legislation.
INSTRUCTIONS FOR USER
CONNECTION AND START-UP
Before carrying out connection, assure that mains voltage corresponds to that on machine plate and that
master switch is on “0” (zero) position.
Position the instrument on a perfectly horizontal surface so as to guarantee an adequate stability; after having assured
that the master switch is on “0” (zero) position, connect feed cable as per the circuit diagram inserting same first in
machine side and subsequently into outlet.
START-UP
Start-up of machine is carried out by a voluntary action on master switch and is evidenced by the warning light on the
front of the machine.
STOP MODES AND EMERGENCY STOP
It is possible to obtain the normal stop function of machine by bringing master switch onto position “0” (zero).
The general emergency stop function may be obtained by disconnecting the feed cable from outlet.
After an emergency stop or stoppage due to an anomaly or lack of electricity, always put master switch
onto position “0” (zero).
WORK EXAMPLES
Start up machine
Position the lens mounted on frame, between the two filters of the machine
(1)
Example of stressed lens (2)
1
Slacken the knob positioned on the back side of the unit, in order to
regulate the angle of the machine, and extract the foot according to needs,
then tighten the knob for blocking the foot in the desired position; this
operation gives the possibility to optimize the reading position. (3)
3
2
MAINTENANCE
Any modification causing an effect on operation or safety of machine, may only be carried out by manufacturer’s
technicians or by technicians formally authorized by same. On the contrary, Essilor declines any responsibility for
changes or damages which may subsequently occur.
Essilor declines any responsibility for improper use of machine, for damages caused by operations not treated in this
manual or which are unreasonable.
All ordinary and extraordinary maintenance operations are to be carried out with machine off, isolating
same from power by disconnecting feed cable.
EXTRAORDINARY MAINTENANCE
Extraordinary maintenance is intended that carried out when machine stops due to break-down of mechanical or
electrical parts.
For safety reasons final user is not permitted to carry out extraordinary maintenance operations. Contact
Essilor or authorized Service Centre.
4
4
