5. Using Standard Outputs
- Unlocking and Locking
Your system has several standard outputs. One output relay is used to unlock the power door locks and another one is used to
lock the door locks. Depending on your type of vehicle and how your installer has hooked up the system, you may be able to
unlock only the driver's door or all of the doors.
-
Interior Lights
A standard feature allows your installer to connect an output to activate the interior lights of your vehicle when any valid user
code is entered on the keypad or the keyfob Unlock Key is pressed. The lights will stay on for about five seconds.
-
Trunk Unlock
Some vehicles come with a power lock on the trunk. Your installer can connect any one of three Keypad or one Keyfob
Auxiliary Outputs to the trunk to allow you to unlock the trunk. From the Keypad you first unlock the vehicle door and then the
trunk. From the Keyfob you can unlock the trunk directly. However, if the vehicle has an alarm system, make sure unlocking
and opening the trunk directly from the Keyfob will not trigger an alarm. Most installers use the Auxiliary Keypad output which
is triggered by pressing the 7/8 Key on the Keypad within 5 seconds of entering a valid unlock code. The 3/4 Key or the 9/0
Key could be used instead of the 7/8 Key for the trunk, or to control other devices on your vehicle. If you are using the trunk
unlock feature, you will first enter your personal entry code followed by pressing the 7/8 Key to open the trunk.
6. Using Auxiliary Outputs
- Keypad Auxiliary Output 3/4 - Press the 3/4 Key within 5 seconds of the last key press of a valid user code.
Note:
This output
may be setup to toggle ON/OFF through a programming command for special control applications.
- Keypad Auxiliary Output 7/8 - Press the 7/8 Key within 5 seconds of the last key press of a valid user code. Normally
connected to the trunk release, if available.
- Keypad Auxiliary Output 9/0 - Press the 9/0 Key within 5 seconds of the last key press of a valid user code.
- Keyfob Auxiliary Output Key (3
rd
Key - lower left) – Press the 3
rd
Key momentarily to activate the controlled function.
- Keyfob Auxiliary Output Key (4
th
Key - lower right – Press the 4
th
Key momentarily to activate the controlled function.
7. Special System Setups
Your system has a special 3-Digit Convenience Code Mode which can be enabled by the system installer or by
following commands listed in the Installer Guide. When the convenience code mode is enabled and the vehicle is
locked by using Lock Code 555, every code in the system will now work by entering only the first 3 digits of the code.
If you have used 7 or 8 digit codes this can be a handy way to allow a friend or service person to have temporary
access by using 3 digits only, and without taking the time to add a new Optional User Code, and without giving away
your personal Master User Code. To lock the doors so a full length Unlock Code is required, use Lock Code 557 or
559. Don't forget, you can always add 3-Digits Optional User Codes for use all the time without activating the
Convenience Code Mode if you wish.
