Assembly Instructions
2
Place Seat upside
down on flat surface.
Note molded Cross
Slots labeled #1 & #2.
FRONT
1
1
Place Guides labeled
#1 over the outer
holes of the top Frame
Tubing #1. Insert
M6 Flat Head Screw
through the hole in
the guide and into the
tubing and tighten
lightly.
3
Place Back Rest on flat
surface with threaded
holes/slots facing up.
5
Place Guides labeled
#2 over the outer holes
of the bottom Frame
Tubing #2. Insert
M6 Flat Head Screw
through the hole in the
guide, into the tubing
and tighten lightly.
Tighten all five (5)
screws with a Phillips
screwdriver until secure
in the seat.
4
Place Frame Tubing
#2 into the Cross Slot
labeled #2. Place
Frame Tubing #1 over
into Cross Slot labeled
as #1. Insert one M6
Round Head Screw
with Curved Washer
through the center hole
where the tubes cross
and screw it lightly into
the threaded insert of
the Seat.
2
Attach the Back Rest
Support Tubing to
the slots of the Back
Rest using the M6
Round Head Screws
with Curved Washers,
as shown. Repeat for
the opposite side.
6
Содержание B3011
Страница 4: ......
