GPR4 Concrete Scanner – User Manual
D-000002-000021
Earth Science Systems, LLC
February 29, 2019
Copyright © 2019 ESS, LLC. All rights reserved.
Page 9 of 28
1. Open the shipping container (see Figure 2) and disconnect the charging cable from the
tablet.
2. Remove the scanner and the tablet from the shipping case. Remove one of the
batteries from the shipping case and attach it to the scanner.
3. If the long handle will be used, remove the three pieces of the long handle from the
shipping case: the wide handle, the telescoping tube, and the scanner clamp. Mount the
scanner clamp to the scanner, then attach the telescoping tube, and finally attach the
wide handle. Adjust the telescoping tube as desired.
4. The tablet computer can be located in one of four locations during the survey (see
Figure 3): on a stand, on the long handle, on the scanner, or held in-hand. For most
surveys, the use of the stand is recommended.
a. For the stand arrangement, connect the long handle and telescoping tube, and
then insert the tube into the holder in the shipping case. Mount the tablet holder
to the wide handle on the stand and then mount the tablet.
b. For the long handle arrangement, mount the tablet holder to the wide handle and
then mount the tablet.
c. For the scanner arrangement, mount the scanner clamp to the scanner and then
attach the wide handle. Finally, mount the tablet holder to the wide handle and
then mount the tablet.
d. For the in-hand arrangement, attached the hand strap to the tablet.
