11
S
AFETY INFORMATION
Operate the FALCON controller always in dry environment and within the device limits stated in this
guide. Never expose the device to excessive heat or cold outside the working area.
Provide sufficient airflow to prevent controller overheating.
Never exceed the maximum allowed operating voltage of the controller/motor.
Do not increase the cable length between the controller and motor. In case you need to lengthen the
wires between the controller and battery to more than 40cm (in total), solder some high capacity low-
ESR capacitors (220-470uF) every 30cm in parallel to the power wires.
Always use high quality connectors in good condition. Replace them if any visible sign of wearing
appears.
Always remove the propeller prior to making any changes in drive setup.
Never disconnect the ESC from the battery while the motor is spinning.
Do not remove the cover and heat sink from the device and do not try to implement any changes or
modifications. This can lead to a total destruction and to the denial of any warranty claims.
Always check the polarity of the connection. Never inverse the polarity – this could lead to total
destruction.
