2
I
NSTALLATION
Install the EX5 in parallel to the flight axes, as close to the center of gravity as possible. By default, the axes printed on the
device point in the direction of flight: x=front, y=right, z=top. In case you need to install the EX5 in a different direction,
please keep in mind that the arrows on the device must be parallel to the flight axes. In such case, the resulting orientation
of the device must be set in the configuration menu.
Please use a soft double sided tape which reduces the vibrations on the sensitive sensor.
Attach the required servos or additional bus extensions to the EX5 (ports 1-5). Connect up to two receivers through their
bus outputs. In case of a single receiver, always connect it to the Rx1 port of the EX5. Turn on the transmitter and apply the
appropriate power source to the EX5. The status LED starts blinking as soon as the EX5 detects signal on the serial line.
Please note that both receivers have to use the same data protocol (e.g. S.Bus).
Basic installation with servos:
Use this installation scheme if you need up to
5 primary servo channels with (optional) flight
stabilization. You can use conversion cables for the
output ports 1-3 to be used with MR30 connectors.
Additional servos may be attached directly to the
receiver Rx1 or Rx2. In such case, please pay
attention to use sufficient cable diameter between
battery and the receiver(s) if high power servos are
used.
Compatibility
: EX Bus, SUMD, S.Bus, SRXL. The EX
Bus offers wireless configuration using the JETIBOX
emulator on the transmitter.
Installation with servos and a single extension port:
Use this installation scheme if you need up to
4 primary servo channels with (optional) flight
stabilization. You can use conversion cables for the
output ports 1-3 to be used with MR30 connectors.
Additional servos may be attached directly to the
receiver Rx1 or Rx2 as written in the previous
example.
Compatibility
: EX Bus, SUMD, S.Bus, SRXL.
EX Bus
: Use port 5 for sensor, SE4 or JETIBOX.
SUMD
: Use port 5 for SMART-BOX or wireless
configuration.
S.Bus and SRXL:
Use port 5 for configuration
through JETIBOX.
