Page 8
Step 8: route voice and/or data wires
Skip this step if voice/data wires will not be used with the unit.
• If routing through the base of an end post, remove the plastic cover at the
base of the post.
• Route the wires up through the post and out the slotted opening above
the rail.
• Route the wires across the top of the rail assembly and down through
the center opening.
• The wires may be routed in other appropriate ways depending
on installation type and installer preference, as long as the
voice/data jacks exit the center of the rail assembly, as shown.
Step 9: reinstall rail assembly side cover(s)
• Reverse the procedure described in step 4.
• Pull the jacks out through the center hole in the side cover before
securing the cover in place.
Railway
™
Assembly
voice/data
wires
rail assembly
side cover
jacks
rail