3
Peel and
Adhere
Clamp Method
The base assembly is shipped with the bottom clamp in the “upper attachment position.” To change to the
“lower attachment position” for thicker work surface, follow this procedure (see illustrations):
• Use the 4mm Allen key to remove the two screws holding the bottom clamp in position.
• Reattach the bottom clamp to the lower two holes. Tighten the screws securely using the Allen wrench.
CAUTION:
Do not use a power drill. Clamp screws are rated at 102 in-lbs.
Attach Clamp Pad
• Peel the backing from the adhesive side of the clamp pad and adhere the pad
to the bottom of the base, as shown. The pad protects the work surface.
Install Base Assembly
• Clamp the base assembly to the work surface. Be sure to tighten the knob
securely.
•
Proceed to “Install Monitor Arms” on page 5.
Two Base Assembly Attachment Methods
•
Clamp method.
The base assembly is clamped to
a table or desk surface that is between 0.6" (15mm)
thick and 3" (76mm) thick. See below.
•
Grommet method.
The base assembly is secured
through a grommet hole in the work surface, with
a diameter between 0.78" (20mm) and 2" (51mm).
Surface thickness must be between 0.6" (15mm)
and 1.5" (38.1mm). See page 4.
Grommet
Method
Clamp
Method
Grommet
Method
Clamp
Method
INSTALLATION OF BASE ASSEMBLY
EDGE2-MS DUAL MONITOR ARM
Bottom
Clamp
Assembly
Upper Attachment
Position (Standard)
Lower Attachment
Position (Optional)
To Change: 1) Remove
Upper Attachment Screws
2) Re-Install Screws with
Clamp in Lower Position
Bottom
Clamp
Assembly
Remove
Re-Install
Upper
Attachment
Lower
Attachment
1.38" – 3"
(35mm – 76mm)
0.6" – 2.2"
(15mm – 56mm)
