All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change.
ESERA GmbH, ESERA-Automation 2020
www.esera.de
11229V2 V2.0 R1.0 Manual
Page 1 of 6
Art. No. 11229 V2
User Guide
8-fold digital output / switching module / binary output
8 x 8A for 1-Wire Bus system
8 power relays with 8x8A continuous power
(in total 10A)
)
LED display for activated relays
Switching of DC or AC consumers, such as
lighting, heating or sockets
DIN rail housing for control cabinet
installation
Standardized and simple software control
Low space requirement in the control
Cabinet
Easy to assemble
1
Introduction
Before you start assembling the
8-fold digital output
and before you take the device into operation, please read
these assembly and operating instructions carefully to the end, especially the section referring to the safety notes.
2
Product description
With the 8-fold digital output, DC and AC loads with a power of up to 8A continuous current per channel and a
total of 10A for all channels can be switched. With non-resistive load the maximum switching capacity is reduced.
The output relay can be controlled directly via a 1-wire interface.
Monostable relays with make-contact are used. If the 12V operating voltage fails, all outputs are switched off and
remain switched off even after a return. In this case, a new switching command via the 1-Wire interface is
required for switching.
To supply the switching module, we recommend the use of one of our 1-Wire Hub modules.
