ESER EU900SA, Руководство пользователя

Страница: 8 / 39

ESER Corporation
Setting Zone
OPERATION
Three zones are preset at factory and select any one of the
zones or combination of zones to set desired cutting length.
There are 6 ways to specify the cutting zone as follows:
Note the zone indicator light stay lit as unit is in operation.
1. I: First zone only
(Left, opposite from control panel)
2. II: Second zone only
(Middle)
3. III: Third zone only
(Right, control panel side)
4. I & II: combination of zones I and II; blade travels across
zone I and II, does not reach zone III.
5. II & III: combination of zones II and III; blade travels
across zone II and III, skip zone I.
6. I,II,& III: combination of all zones; blade travels entire
length of the cutter.
1. Turn power off by pushing [OFF] button at POWER.
2. Turn power on by pushing [ON] button at POWER.
3. Push [SET] button at SETTING.
4. Push [upper/lower arrow] button once at a time until the
desired zone setting is achieved, see above light setting.
Make sure the indicator light stays lit; 1 light for single
zone, multiple lights for combination of zones.
5. Push [ON] button at AUTO. Resume auto cutting.
Setting Procedure
Page 5 of 36