ESE RETRON BOX, Руководство пользователя

Страница: 6 / 11

RETRON BOX – USER GUIDE
6
5. ASSEMBLY
The RETRON BOX is supplied in a pre-assembled condition and is ready to use for transporting and storing lithium
ion batteries. If the RETRON BOX is going to be used to store your lithium ion battery while it is being charged,
route the charging cable through the cable guide into the RETRON BOX. You can fit up to two charging cables
using the cable guide.
5.1 FITTING THE CHARGING CABLE IN THE CABLE GUIDE
1. Move the lever of the snap locks into the ‘open’ position (Section 3.1, Fig. 2) and remove the lid of the
RETRON BOX.
2. Now unscrew the union nut (1) of the cable guide on the inside of the RETRON BOX. (Section 5.1, Fig. 3)
3. Pull the cable guide out towards the outside. (see Fig. 3)
4. Remove the outer casing sections (2) of the cable guide. (see Fig. 4)
5. Using a screwdriver, split the outer casing sections (2) of the cable fitting. (see Fig. 4)
6. The rubber part (3) of the cable guide can now be pulled out. (see Fig. 4)
7. Depending on the number of cables being used, remove one or both stoppers (4) from the rubber part of
the cable guide. (see Fig. 4)
8. Insert the charging cable into the slot.
9. Reattach the casing sections (2) of the cable guide. (see Fig. 4)
10. Push the cable guide from the outside into the hole in the RETRON BOX. (see Fig. 3)
11. Push the connector of the charger in the RETRON BOX through the union nut.
12. Screw back on the union nut (1) of the cable guide on the inside of the RETRON BOX. (see Fig. 3)
Fig. 3: Removing the cable guide Fig. 3: Removing the cable guide
1
2
3
4