Hardware Installation
VME-DIO32-L
Hardware Manual Doc. Nr.: M.1607.27 / Rev. 1.0
Page 15 of 22
3 Hardware Installation
NOTICE
Read the safety instructions at the beginning of this document carefully before you
start with the hardware installation!
WARNING
Hazardous Voltage -
Risk of electric shock
due to unintentional contact with
uninsulated live parts with high voltages inside of the system into which the
VME-DIO32-L is to be integrated.
→
→
Disconnect all hazardous voltages (mains voltage) before opening the system.
Never carry out work while power supply voltage is switched on!
Ensure the absence of voltage before starting any electrical work.
NOTICE
Electrostatic discharges may cause damage to electronic components.
→
→
To avoid this, please discharge the static electricity from your body
before
you touch
the VME-DIO32-L.
Furthermore, you should prevent your clothes from touching the VME-DIO32-L,
because your clothes might be electrostatically charged as well.
Procedure:
1. Switch off your system and all connected peripheral devices (monitor, printer, etc.).
2. Discharge your body as described above.
If necessary, configure the VMEbus address via the rotary switch and the DIP switches as
described in chapter
from page 12. The lower VMEbus address can also
be easily set later via the rotary switch in the front panel.
3. Disconnect the VME system from the mains.
Make sure that no risk arises from the system into which the VME-DIO32-L shall be inserted.
WARNING
Hazardous Voltage
Risk of electric shock due to unintentional contact with uninsulated live parts with high
voltages.
→
→
→
→
Disconnect all hazardous voltages (mains voltage) before opening the system.
If the system does not have a flexible mains cable, but is directly connected to
mains, disconnect the power supply via the safety fuse and make sure that the fuse
cannot switch on again unintentionally (e.g. with caution label).
Ensure the absence of voltage before starting any electrical work.
Cover or block off adjacent live parts.
4. Insert the VME-DIO32-L board into the selected slot.
Carefully push the board into the slot until it snaps into place.
5. Fix the module.
6. Connect the system to mains again (mains connector or safety fuse).
7. Switch on the system and the peripheral devices. - End of hardware installation.
