Escorts FarmTrac 45 DT, Руководство оператора

Страница: 52 / 73

SECTION B
Operation 45 - Hydrostatic steering oil filter
(where fitted)
Disconnect the pipes at the unions (2) and (3), see
Figure 41 .Remove the bolt (1), ease the reservoir casing
rearwards and catch the oil in a suitable container.
41. Hydrostatic Steering pump
1. Bolt 2. & 3. Union
Discard the filter (1) and ‘O’ ring (2) and clean the pump
and reservoir, see Figure 42. Fit a new ‘O’ ring and filter
and install the reservoir.
Refit the oil pipes and fill the reservoir to within 0.75 in
(19 mm) of the filter neck.
With the engine running, bleed the system by turning
the steering wheel from lock to lock several times.
Recheck the oil level and top up, as required.
Operation 46 - Rear Axle Oil
With the oil hot, remove the drain plug, Figure 43, and
allow the oil to drain into a suitable container. Replace
the plug after the oil has completely drained.
Unscrew and remove the filler and level plugs, Figure
44, and refill the rear axle until the oil reaches the level
plug hole in the right-hand side of the rear axle center
housing.
See Section C for oil capacity and grade.
43. Rear Axle
1. Drain plug
44. Rear Axle
1. Level plug
2. Filler plug
Operation 47 - Hydraulic Strainers
The inlet and outlet strainers, which are located in the
rear axle center housing, should be inspected and
cleaned or replaced, as necessary.
This service should be carried out by your Authorized
Dealer.
17
1
3
2
42. Hydrostatic steering oil filter
1. Filter 2. ‘O’ ring
2
1