Escient FireBall SE-D1, Руководство по запуску

Страница: 141 / 189

FIREABALL REMOTE CONTROL GUIDE WD046-1-2
9/30/2005
6640 Intech Blvd. Suite 250 Indianapolis, IN 46278 317.616.6789 phone 317.616.6790 fax www.escient.com
Step and Set (991)
In the event that the device code for a component is unknown, the user can cycle the remote
through the available codes for that device mode and sample functions from each code in
order to find the code that properly operates the component. The keys available to be
sampled, provided they are applicable to that mode are: 0, 1, 2, 3, Power, Channel Up,
Volume Up, Play and Stop. Invalid key presses will be ignored while in Step and Set
programming state.
To cycle through each available device code and sample its functions:
Mode
Æ
<<Code Set>>
Æ
9
Æ
9
Æ
1
Æ
Function 1 [Function 2
Æ
… Function N]
Æ
Mode
Æ
Code Set
The available functions within a code may be sampled as many times as desired until
advancing to the next code by pressing the Mode key. Pressing Code Set listed at the end of
the sequence will then program the remote with the device code that was last sampled.
The search function will indicate it has cycled through all of the available codes by blinking the
LED three times. The remote will begin to cycle through the available codes again. The LED
will light each time a function is sent. If no key is pressed within 10 seconds, the remote will
exit the set up mode and return to the code previously set up before “Step and Set” was
initiated. The remote will blink two times after successful completion of the programming
sequence. The remote will time out after 10 seconds during programming if no keys are
pressed.
Volume Lock (993)
The user will lock volume to one mode as follows (a.k.a. Global Volume Lock):
<<Code Set>> Æ <9> Æ <9> Æ <3> Æ <Desired Mode>
The user will reset the volume controls to be that of the original device code as follows (a.k.a.
Global Volume Unlock):
<<Code Set>>
Æ
<9>
Æ
<9>
Æ
<3>
Æ
<Volume Up>
The remote will blink two times upon being locked and blink 4 times when unlocked.
If user wants to unlock volume for a specific mode (a.k.a. Individual Volume Unlock):
Mode
Æ
<<Code Set>>
Æ
<9>
Æ
<9>
Æ
<3>
Æ
<Volume Down>
The remote will blink 4 times upon being unlocked.
The remote will time out after 10 seconds during programming mode if no keys are pressed.