Step 2: Connect the Component to HDMI Adapter
1. Connect the included component video cable and digital audio cable
between the Sony changer’s outputs and the inputs on the video adapter.
2. Connect your HDMI cable between the video adapter HDMI output and
the first HDMI input on the Vision.
3. Insert the DC side of the power supply into the video adapter.
4. Insert the AC side of the power supply into the wall outlet.
Step 3: Connect the Keyspan USB to Serial Adapter
1. Connect the included USB cable between the top USB port on the rear of
the Vision and the Keyspan Serial adapter.
2. Connect a null modem (female to female) RS-232 cable (not included) to
the DB-9 male connector side on the Keyspan Serial adapter.
Step 4: Configure the Sony Changer’s Back Panel Switches
1. Make sure the COMMAND MODE switch is set to 1.
2. Make sure the COMPONENT VIDEO OUT switch is set to
PROGRESSIVE.
Step 5: Turn on your Vision
Press and release the power button on the front panel of the Vision and wait for it
too boot up. The boot process is complete when the power LED changes to
blue.
Step 6: Lookup Changer Discs
After Vision is fully running, you can start the disc lookup process. To initiate the
initial lookup of all of the DVDs in the changer you must open and close the
changer door using the Sony’s front panel OPEN/CLOSE button. Vision will then
begin to identify all of the changer discs. This may take up to an hour and a half
for a full changer.
Audio Configuration
Configure the Sony Changer’s Digital Audio Settings
The Sony DVP-CX777ES changer’s digital audio output must be set to output
Digital 5.1 and not PCM. Use the Sony remote and on screen menus to change
the digital audio output setting.
Follow these steps using the SONY CHANGER REMOTE to set the correct
audio settings on the changer:
1. While a movie is playing form the changer press STOP.
2. Press the DISPLAY key to show the changer’s on screen menu system.
