2.
Basic Operation
− Initial Start / Battery Placement
Remove the battery cover on the rear of the remote. Insert the new “AA” size batteries, being careful of
the polarity. You should now see on the display of the remote the time showing “0:00”. To turn the fire
on, press the “POWER” (2) button once, and within a few seconds the appliance will begin its startup
sequence.
NOTE: The appliance begins its startup with a fifteen second pre-ignition purge, where the combustion fan runs
on its own before it tries to ignite. Between ignition attempts the remote will alternately show the remote’s “Set”
temperature and a rotating segment indicator to show that the fire is in start up mode and will try to ignite
again.
− Adjusting the Room Temp
To set the room temperature, press the ‘plus’ (8) or ‘minus’ (4) buttons repeatedly until the display is show-
ing the desired temperature. The remote will then revert back to the ‘current’ room temperature after 30
seconds. The lowest flame setting will run continuously whilst the medium and high settings will operate
according to the temperature set by the remote.
− Fan Boost
The fire has four FAN SPEED settings. The first low fan speed will run automatically on start-up. The
second and third fan speed will automatically switch on or off with the increase or decrease of the set
temperature, and the forth fan speed is an optional FAN BOOST speed, which can be accessed on your
remote. Pressing the FAN BOOST button (7) will increase the fan speed to its maximum. When this mode is
not on, the fire will still use fan speeds one, two, and three.
NOTE: The maximum flame setting will ONLY come on in Fan Boost mode.
− Effect Only
Pressing the EFFECT ONLY button (3) will only turn on the lowest setting on the front burner only. This
mode is intended as an ambient effect, although some heat will still be produced, and the room air fan
will operate at its lowest setting in this mode.
NOTE: The room air fan may continue to operate for a few minutes after the fire has been switched off to
remove any excess heat.
3.
Setting the Time
Press and hold the “SET TIME” button (6) for more than two seconds and this will allow you to set the hour
including “AM” or “PM” using the PLUS (8) or MINUS (4) buttons.
Pressing the “TIME SET” button (6) again will allow you to set the minutes.
Press the button one more time to exit the “SET TIME” mode.
