3
B) Detached Tabletop Display Configuration
1. Unscrew the two
13 mm Screws
connecting the
Display Unit
to the
Metal Display Mount
, and save the two
13 mm Screws
for step 8.
Skip steps 2-3 for D) Standing Mount Display Configuration.
2. Unscrew the two
14 mm Screws
that attach the
Metal Display Mount
to
the underside of the scale. Spin the
Metal Display Mount
around so it
no longer protrudes from the underside of the scale and reattach it with
the
Spacing Washers
remaining inbetween.
C) Wall Mounted Display Configuration
3. Add the
Coiled Extension Cord
to the
Display Cord
.
4. Remove the four
7 mm Screws
from the two
Grey Brackets
located
underneath the
Display Unit
, and save the
7 mm Screws
for step 6.
5. Tuck the
Display Cord
all the way into
Notch A
at the top of the
Vertical
Arm
, and slide the
Vertical Arm
into the
Display Unit
. It will be a tight fit.
Reference the Vertical Arm drawing on page 2 to locate Notch A.
6. Use the four
7 mm Screws
saved from step 4 to fasten the
Vertical Arm
to the
Display Unit
.
Skip step 7 for D) Standing Mount Display Configuration.
7. Attach the two
Wall Mount Screws
to a wall vertically spaced and 4
cm apart on center. Hang the
Vertical Arm
and
Display Unit
on the
two
Wall Mount Screws
.
Pre-drill 1/4 inch diameter holes for the Drywall
Anchors when mounting onto a drywall surface, or 3/32 inch diameter
holes for the Wall Mount Screws alone.
D) Standing Mount Display Configuration
8. Use the two
13 mm Screws
saved from step 1 to attach the
Metal
Display Mount
inbetween the rubber feet of the
Vertical Arm
. The
Metal Display Mount
should protrude in the direction the
Display Unit
is facing.
9. Plug the
Display Cord
into the scale.
Attention!
Save all unused parts for future reconfigurations.
PRODUCT SUPPORT
24/7 Online community support:
http://escali.zendesk.com
Email support:
Phone support:
1-800-467-6408
Содержание RL136
Страница 7: ...7 NOTES...