Replacement Parts List
Item #
Part #
Description
Qty.
1
4A-6536-02
Half Top
2
2
2S-6384-00
Side Rail (48" Long)
4
3
2S-6385-00
End Rail (53" Long)
2
4
2S-6429-02
Stiffener Rail
2
5
BZ-412
Sponge Rubber Strip
12
6
1B-6482-00
#8 X 13/32 Phillips Hex Hd
48
7
2L-6713-02
This Owner's Manual
1
8
3M-6494-00
Corner Cap
4
9
701-105
#8 X 9/16 Phillips Hex Hd
12
1.
Determine the placement of sponge rubber strips #5 on the bottom of
half tops as follows (Use Figure 1):
BOTTOM SIDE OF HALF TOPS #1 SHOWN
TOP SIDE OF HALF TOPS #1 SHOWN
WITH POOL TABLE UNDERNEATH.
Figure 1
INSTALLATION
Figure 2
If incorrectly placed, mark the correct position on bottom of the conversion
top, remove top from pool table, and apply strips. Repeat on other half.
Set both half tops on pool table.
3.
Install net brackets and net (not furnished with this table).
MAINTENANCE
We do not recommend the use of wax on this top. Wax tends to make the
top excessively shiny.
To clean, use a warm, damp cloth and
WIPE GENTLY!
DO NOT WIPE
EXCESSIVELY! DO NOT USE DETERGENTS OR EXCESSIVE
AMOUNTS OF WATER!
NOTE:
Changing weather conditions may cause a slight warpage in the
playing surface of the table. This will not affect playing conditions. Playing
surface will return to its original condition as the weather stabilizes.
STORAGE
This table MUST be stored indoors.
2L-6713-02
Mark center line (
A
) along the length of conversion top. Top is 60
inches wide. Center line (
A
) is 30 inches in from either side.
Measure the width of your pool table.
Divide the width of your pool table in half and mark the bottom of the
conversion top this amount (
B
). Measure from center line (
A
) out toward
both sides. These mark the sides of your pool table.
Measure the length of your pool table.
Divide length of pool table in half and mark the bottom of the conversion
top this amount (
D
). Measure from center line (
C
) (where two half tops
touch) out towards both ends. These mark the ends of your pool table.
Temporarily tape sponge rubber strips #5 to bottom surface of
conversion top using masking tape (not included). Space them evenly
apart as shown above. (Do not peel backing off strips yet. First check
for correct placement. See next step.)
2.
Set one half top on your pool table to check for correct placement of
sponge rubber strips #5.
If correctly placed, remove top from pool table, peel backing from sponge
rubber strips #5 and apply firmly to back of conversion top. Repeat on
other half top. Place both half tops on pool table.
LIMITED 90 DAY WARRANTY
Manufacturer warrants to the original retail purchaser, this product to be free from
defects in material and workmanship for a period of ninety (90) days from the date
of purchase.
Should this product become defective due to material or workmanship within the
warranty period, contact our Customer Service Department for repair or replacement
at our option.
This warranty is not transferable and does not cover normal wear and tear, bowing
of the table or damage caused by improper handling, installation or use of this
product. This warranty is also void if product is in any way abused, damaged, or
modified from its original state, or if used for other than residential use.
This warranty gives you specific legal rights, and you may have other rights which
vary from state to state.
