4.
A)
Attach two 1" Plastic Clips (
#23
) to bottom of aluminum top assembly using four Screws (
#15
) as
shown in
FIGURE 4
and
DETAIL B
.
B)
Attach U-Leg (
#1
) with two 1-1/2" Plastic Tube Brackets (
#27
) as shown in
FIGURE 4
and
DETAIL A
. Attach with twelve Screws (
#15
).
CAUTION: Slots in Plastic Tube Brackets (#27)
must face toward middle of table exactly as shown or the table will not operate properly.
C)
Attach U-Support (
#3
) with two 1" Plastic Tube Brackets (
#24
) as shown in
DETAIL B
. Attach with
twelve Screws (
#15
).
CAUTION: slots in Plastic Tube Brackets (#24) must face toward middle
of table exactly as shown or the table will not operate properly.
D)
Rotate U-Leg (
#1
) and U-Support (
#3
) until you see the screw hole in the slot of Tube Bracket (
#27
)
and (
#24
). Slide U-Leg and U-Support side to side if necessary to see hole. See
DETAIL A & B
.
E)
Thread two Screws (
#16
) through slot in Plastic Tube brackets (
#24
) & into U-Support (
#3
) and two
Screws (
#16
) through slot in Plastic Tube Brackets (
#27
) & into U-Leg (
#1
) as shown in
DETAIL A
&
B
.
F)
Slide two Plastic Leg Caps (
#20
) onto ends of U-Leg (
#1
).
Parts Needed:
1 pc -
#1
U-Leg-Silver
1 pc -
#2
Aluminum Top Assembly
1 pc -
#3
U-Support-Silver
2 pcs -
#20
Plastic Leg Cap
2 pcs -
#23
1” Plastic Clip
2 pcs -
#24
1’’ Plastic Tube Bracket
2 pcs -
#27
1-1/2” Plastic Tube Bracket
Figure 4
Hardware Needed:
28 pcs -
#15
Phillips Rd. Hd. Screw
4 pcs -
#16
Phillips Rd. Hd. Screw
NOTE: All Tube Bracket Slots face toward
middle of the table. As shown in Figure 4.
20
1
3
23
24
27
2
DETAIL B
Tube Bracket Slots
6
Middle of table is
end without stripe.
NOTE: Tighten screws snug,
but do not overtighten, causing
screws to strip in metal tube.
15
16
1
3
16
15
27
24
23
DETAIL A
15
16
15
16
Содержание STIGA T8561
Страница 10: ......
