INSTALL RIM EXACTLY AS SHOWN. FAILURE
TO DO SO COULD DAMAGE GLASS.
it is level. Finish tightening the four nuts.
Place a level across rim assembly and adjust rim until
19.
18.
Mount Goal Assembly (#28) and Rim Pad (#27) to
Backboard, as shown in Figure 12, using four bolts
(#29), washer (#26) and four nuts (#24). Tighten
Fasteners finger tight, leave loose enough to level
rim.
10
20.
21.
22.
23.
Use the Backboard Pads as a Template and mark the hole locations on the backboard frame.
Note: Safety glasses required for Step 21.
Drill 9/64 pilot holes through aluminum trim and into Steel backboard frame as shown in
Detail C
.
DO
NOT
drill through both sides of tube.
Note: Cordless drill recommended for screw installation. Do not over tighten screws.
Secure Backboard pads using screws provided (
#12
). Start with the Right Board Pad (
#44
) secure it by
screwing the top (
#12
) screw all the way in. Next Insert the other two (
#12
) screws to the pre-drilled holes
enough to hold pad but
do not
tighten all the way.
Slide Middle Pad (
#46
) into the (
#44
) pad and insert screw (
#12
) to the pre-drilled holes to hold pad in
place.
Do not
tighten all the way.
Attach Left Board Pad (
#45
) and secure it by screwing the top (
#12
) screw all the way in. Next Insert the
other two (
#12
) screws to the pre-drilled holes to hold pad but
do not
tighten all the way. Slide pads
together and tighten all screws at this time.
24.
*Rim not
shown for
clarity.
12
Attach
First
44
46
45
Detail C
Screw #12
Backboard
Pad #44 & #45
Steel Frame
Do not drill top
of steel tube
Figure 13
Figure 12
Содержание Goalrilla CV B3202F
Страница 2: ...2 4L 8090 01...
Страница 15: ...15 2L 7217 01 1 12 12 12 45 44 Right Left 46 Middle 49 19 18 3 5 48 25 47 48 25 5 3 18 19 47 24 47 47 24 12...
Страница 16: ...16...
