User Manual
esatto.house
14
15
Installation Instructions (Continued)
INSTALLATION OF THE UNIT INTO THE HOUSING
1.
Slide the unit into the housing until it is firmly
against the rear of the housing. Care is required
to ensure the foam sealing strips on the housing
remain in position.
2.
Connect the air conditioner to the power and
position excess cord length beneath the air
conditioner base.
3.
Engage the chassis fixing brackets into the bottom
housing rail and secure to the base with the screw
provided.
4.
Remove the front panel from it’s carton and
plastic bag and fit as per the Installation
lnstruction.
5.
Switch unit on. Check for operation of the unit
and check for vibration in the installation.
6.
Fit the drain pan to the housing and run a drain
line to a suitable location if required.
INSTALLATION OF THE UNIT INTO THE WALL
INSTALLATION STEPS
Step 1. Remove the front panel and the air filter
1.
Hold the slot under the front panel, then uplift it outwards, and remove the front
panel (See Fig. 1).
2.
Pinch the handle under the air filter and make the air filter arched, remove it
from the slot from underside to upside (See Fig. 2).
Fig. 1
Fig. 2
Fig. 3D
Fig. 3C
Fig. 3B
Fig. 3A
Fig. 4
Step 2. Remove the frame
1.
To meet different requirement of different type of air conditioner, there are four
kinds of removing the frame.
• Remove the two screws on the left and right chassis fixing brackets, then
remove the two chassis fixing brackets as shown in Fig. 3A.
• Remove one screw on the chassis fixing bracket, then remove the chassis
fixing bracket. Remove the two screws located on the back of the cabinet
as shown in Fig. 3B.
• Remove one screw on the chassis fixing bracket, then remove the chassis
fixing bracket as shown in Fig. 3C.
• Remove the four screws located on both sides and the back of the cabinet
as shown in Fig. 3D.
2.
Grasp the left corner of the frame’s underside, release the coupler plugs, then
loosen the frame (See Fig. 4).
