Esatto EUF418W, Руководство пользователя

Страница: 10 / 24

User Manual 10
Installation
• Two person installation: Use two or more people to move and install the appliance. Failure to
do so can result in back or other injury.
• Freestanding design: This appliance is designed to be freestanding only, and should not be
recessed or built-in.
• Floor surface: This appliance must be properly positioned on a dry, sturdy, level surface that is
strong enough to support it when it is fully loaded.
• Ambient temperature: The ambient temperatures must correspond to the climate class ( ST/N )
indicated on the rating plate of the appliance: 16° C – 38° C
• Clearances: Ensure that air can circulate freely around the back of the cabinet, which is
necessary to cool the compressor and condenser. Allow at least 10cm clear space at the back,
10cm at the sides of the unit and 30cm between the top and any surface above (i.e. a bench
top). If you are installing your refrigerator next to a fixed wall, leave sufficient space on the
hinge side to allow for the door to swing open.
Do NOT install/use the appliance in the following locations/situations:
• In moist areas or areas of high humidity.
• In a recreational vehicle, or for use with an inverter.
• In direct sunlight, near heat sources, next to an open flame, cooking or heating appliance, or
near any other source of high heat.
• Direct sunlight may affect the acrylic coating and heat sources may increase the unit’s power
consumption. For best energy efficiency install the appliance in the coolest area of the room.
• In an area with extreme cold ambient temperatures.
• In an area with excessive moisture and high humidity. Make sure it is protected from elements
such as wind, rain, water spray or drips.
• In an area where petrol or other explosive and/or flammable liquids or fumes are used or
stored. The fumes can create a fire hazard or explosion.
ELECTRICAL CONNECTION
• WARNING! It must be possible to disconnect the appliance from the mains power supply; the
plug must therefore be easily accessible after installation.
• Before plugging in your new bar fridge, let it stand upright for at least 2 hours. This will allow
the refrigerant gases to settle into the compressor and reduce the possibility of a malfunction
in the cooling system.
• The appliance must be earthed. The plug of the power supply cord is equipped with a contact
for this purpose. Do not under any circumstances cut or remove the third (earth) prong from
the power cord.
If the plug does not fit your outlet, consult a licensed electrician for advice to have the outlet
changed.
• Plug the unit into a dedicated, properly earthed wall outlet. Ensure that your outlet voltage
and circuit frequency correspond to the voltage stated on the rating label.
• Secure the bar fridge’s supply cord behind the unit. Do not leave it exposed or dangling to
prevent injury and accidental disconnection from the power supply.
• Adjust the temperature control as described below.
• When first starting up, and after a period out of use, allow the unit to cool down for at least
2–3 hours (4 hours if starting up during warm weather in summer) before placing food in the
bar fridge.