ESAB YardFeed 200, Руководство по обслуживанию

Страница: 3 / 30

S0740 800 148/E060619/P30
-- 3 --
cwfu2de1
READ THIS FIRST
Maintenance and repair work should be performed by an experienced person, and
electrical work only by a trained electrician. Use only recommended replacement parts.
This service manual is intended for use by technicians with electrical/electronic training for
help in connection with fault--tracing and repair.
Use the wiring diagram as a form of index for the description of operation. The circuit
board is divided into numbered blocks, which are described individually in more detail in
the description of operation. All component names in the wiring diagram are listed in the
component description.
This manual contains details of all design changes that have been made up to and
including May 2006.
The manual is valid for:
ESABFeed 30--2
M11
with serial no. 238--xxx--xxxx, 410--xxx--xxxx, 440--xxx--xxxx.
ESAB YardFeed 200
and YardFeed 200 with serial no. 548--xxx--xxxx, 612--xxx--xxxx.
The ESABFeed 30--2 M11,
YardFeed 200
and ESAB YardFeed 200 are designed and
tested in accordance with international and European standard IEC/EN 60974.
On completion of service or repair work, it is the responsibility of the person(s) etc.
performing the work to ensure that the product does not depart from the requirements
of the above standard.
INTRODUCTION
The ESAB YardFeed 200 is renamed, the new name is YardFeed 200.
The wire feed unit ESABFeed 30--2 with control panel M11 is
intended for MIG/MAG--welding together with step controlled
welding power sources.
It can be used together with wire on ESAB’s MarathonPac
t
,
or on wire bobbin (standard Ø 300 mm, accessory Ø 440 mm).
The wire feed unit can be installed either at the power source,
suspended above the workplace, on a support arm or on the
floor with or without wheel set.
The wire feed unit YardFeed 200 with control panel M13y, is intended for MIG/MAG welding
together with stepped and thyristor--controlled welding power sources.