ESAB Railtrac B42V, Инструкция по эксплуатации

Страница: 14 / 26

4 OPERATION
0463 465 001
- 14 -
© ESAB AB 2016
4 OPERATION
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!
4.1 Preheat
The first menu in service is Preheat . Start delay carriage after start welding.
WFS = Wire Feed Speed
1. Press Stop for 6 seconds for access to
service menu A.
2. Release Stop when the display shows
Service Menu A .
The electronics will stay in the service menu
5 seconds after last button press.
3. The default setting is 300 ms.
Press
+ or - to adjust the setting.
4.2 Remote control for digital wire feeder
It is possible to adjust the maximum value on the remote control output (0-10 V) both for wire
feed speed and volt. The maximum value is 0.5 V lower than V
in
(10 V) due to the voltage
drop in the opto driver.
Set Wire Feed Speed (WFS)
1. Press Menu once.
The display shows: DigF max WFS
2. Press + or - to adjust the setting.
Scale value: 1 - 40
Higher value gives higher output.
Set Voltage (V)
1. Press Menu until DigF max V is shown in the
display.
2. Press + or - to adjust.
Scale value: 1 - 40
Higher value gives higher output.
General safety regulations for handling the equipment can be found in the "SAFETY"
chapter of this manual. Read it through before you start using the equipment!