ESAB Powercut 650, Инструкция по эксплуатации

Страница: 29 / 56

29
5.5 re-fitting the pt-31xlpc torch
1. For operator safety, the torch connections are located on the output terminal board behind
the lower portion of the front panel. Remove access cover to torch connection compart-
ment from the front panel of power source.
2. Thread the power cable and switch lead of the PT-31XLPC through the Strain Relief on the
Access Cover. Connect power cable to the torch fitting (left-hand threads) and plug in the
switch lead to the torch switch receptacle on the output terminal board. Make sure the
power cable connection is wrench-tight. Make sure plug of switch lead is firmly locked in
place.
3. Reassemble the access door to the power source. Retighten Strain Relief to secure power
cable, but do not overtighten.
ACCESS COVER FOR
TORCH CONNECTIONS
WORK CLAMP &
CABLE ASSEMBLY
TORCH TRIGGER LEAD CONNECTION TORCH POWER CABLE CONNECTION
PT-31XLPC
Plasma Cutting
Torch
figure 5-4. pt-31xlpc torch connections
STRAIN RELIEF
section 5 maintenance