ESAB PEH A2, Инструкция по эксплуатации

Страница: 24 / 40

-- 24 --
doce
5 MANUAL OPERATION
5.1 Travel and wire feed
Travel and wire feed commands can be given when not welding, as follows:
Switch on welding power source
S
The direction of travel is as shown by the square symbol on the power
source.
Normal speed
.
S
The direction of travel is as shown by the triangular symbol on the power
source.
Normal speed
.
To stop travel described above, press the same key again.
S
Retract wire. Normal speed .
Wire continues to retract until you release the key.
S
Advance wire. Normal speed .
Wire continues to advance until you release the key.
S
After switching on, you can select maximum speed by pressing the fast key
.
The LED in the key lights up.
S
To return to normal speed press the fast key again .
To stop immediately, press , or even at max. speed.
Normal speed and max. speed can be adjusted under “PRESET SYSTEM MENU”.
5.2 Controlling valves
To operate a valve you must be in the “MAIN MENU”.
S
Open the valve for flux or gas by pressing .
S
Close an open valve by pressing the same key .