ESAB MultiPower 460 Pulse, Инструкция по эксплуатации

Страница: 17 / 52

17
Figure 2-6. Remote Control Pendant
DESCRIPTION
SECTION 2
NOTE
If a Foot Control or Remote Hand Control
is used for continuous current control,
place the PANEL/REMOTE switch in the
PANEL POSITION and set the Panel Cur-
rent knob to the maximum desired weld
current. The remote device will then con-
trol the current between minimum and the
maximum setting preset (proportional
current control). Maximum Tig weld cur-
rent is 525 amps.
NOTE
The FC-5B foot control or TC-2B hand
control must be used with the MP-460 for
remote current Tig current control.
NOTE
If the MP-460 PANEL/REMOTE switch
is left in the REMOTE position when Tig
welding while using a remote current
control device, the current range will
be full scale or 10 to 400 Amps.
Limiting the the Maximum weld current
on the MP-460 front panel is defeated.
NOTE
When using a DuraDrive wire feeder
(or any wire feeder with Remote
Voltage control from the feeder front
panel) connected simultaneously with
a remote current control Tig device
(FC-5B or TC-2B), proportional control
of the TIG remote current will be
controlled by the position of the feeder
voltage control knob when the PANEL/
REMOTE switch is in the REMOTE
position. When in the PANEL position
the maximum current of the remote
device is controlled by the MP-460
front panel current control preset.
NOTE
When using the MP-460 Pulse, the
STANDARD/PULSE switch must be in
the STANDARD position for
proportional current control using a TIG
remote current device (FC-5B or TC-
2B).
4. TIG REMOTE CONTROLS
The following Remote controls are available for the Tig welding:
FC-5B EHD Foot Control 33841
FC-5B Foot Control 33838
TC-2B Torch Mount Control 33839
TC-3A Torch Mount On/Off only:
(HW-9, 17, 20, 20A & 24)
35783
(HW-18 & 26R) 36680