ESAB Buddy Arc 180, Инструкция по эксплуатации

Страница: 8 / 20

© ESAB AB2011
- 8 -
bh40d1e
5 OPERATION
General safety regulations for handling the equipment can be found on
page
4 . Read through before you start using the equipment!
5.1 Connections
1 Control panel 4 Mains power supply switch 1/O
2 Connection (-) for return cable, welding
cable or TIG torch 5 Connection for mains cable
3 Connection (+) for return cable or welding
cable
5.2 Connection of welding and return cable
The power source has two outputs, a negative [-] terminal (2) and a positive [+]
terminal (3), for connecting welding and return cables.
For MMA process the output to which the welding cable is connected depends on
the type of electrode, please refer to electrode packaging for information relating to
the correct electrode polarity.
For optional TIG process, connect the TIG torch power cable to the negative [-]
terminal (2). Connect gas inlet nut to a regulated shielding gas supply.
Connect the return cable to the remaining welding terminal on the power source.
Secure the return cable's contact clamp to the work piece and ensure that there is
good contact.
GB
ARC WELDING SUPPLIES - 07 847 7870