ESAB AristoFeed 30, Инструкция по эксплуатации

Страница: 16 / 44

-- 16 --
bm29d1ea
WARNING
READ AND UNDERSTAND THE INSTRUCTION MANUAL BEFORE INSTALLING OR OPERATING.
ARC WELDING AND CUTTING CAN BE INJURIOUS TO YOURSELF AND OTHERS. TAKE PRECAU-
TIONS WHEN WELDING. ASK FOR YOUR EMPLOYER’S SAFETY PRACTICES WHICH SHOULD BE
BASED ON MANUFACTURERS’ HAZARD DATA.
ELECTRIC SHOCK -- Can kill
S
Install and earth the welding unit in accordance with applicable standards.
S
Do not touch live electrical parts or electrodes with bare skin, wet gloves or wet clothing.
S
Insulate yourself from earth and the workpiece.
S
Ensure your working stance is safe.
FUMES AND GASES -- Can be dangerous to health
S
Keep your head out of the fumes.
S
Use ventilation, extraction at the arc, or both, to take fumes and gases away from your breathing zone
and the general area.
ARC RAYS -- Can injure eyes and burn skin.
S
Protect your eyes and body. Use the correct welding screen and filter lens and wear protective
clothing.
S
Protect bystanders with suitable screens or curtains.
FIRE HAZARD
S
Sparks (spatter) can cause fire. Make sure therefore that there are no inflammable materials nearby.
NOISE -- Excessive noise can damage hearing
S
Protect your ears. Use earmuffs or other hearing protection.
S
Warn bystanders of the risk.
MALFUNCTION -- Call for expert assistance in the event of malfunction.
PROTECT YOURSELF AND OTHERS!
WARNING!
Read and understand the instruction manual
before installing or operating.
3 INTRODUCTION
Note! This product is solely intended for arc welding.
The AristoFeed 30 and AristoFeed 48 wire feed units are intended for use with the
AristoMig 400 power source.
There are several variants available: see the spare parts list on page 27.
They are totally enclosed, containing four--wheel feeders and the necessary control
electronics.
They are suitable for use with wire on ESAB’s MarathonPac
t
, or on standard
bobbins (maximum diameter, 300 mm).
The units can be positioned in a choice of ways: on the power source itself, hanging
above the working position, on a support arm or with a wheelset on the floor.
Details of ESAB’s accessories for the wire feed units can be found on page
38.
GB