ESAB Aristo WeldCloud Mig U5000i, Инструкция по эксплуатации

Страница: 14 / 28

5 OPERATION
0459 087 687 - 14 - © ESAB AB 2017
5.1 Connections and control devices
1 Orange indicating lamp - Overheating 14* *Only on WeldCloud™ version: Red
indicating lamp - Wi-Fi Connectivity
2 White indicating lamp - Power supply ON 15 Fuse for supply voltage for feeder unit,
42 V
3 Mains power supply switch, 0 / 1 /
START 16* *Only on WeldCloud™ version:
Connection for Ethernet
4 Connection for start signal from the torch 17 Measure outlet screw terminal Red (+)
5 Connection for gas to the TIG torch 18 Measure outlet screw terminal Black (-)
6 Connection (-) for return cable at SMAW
and GMAW or for welding current cable
at TIG (GTAW) 19 Connection for control cable to the wire
feed unit or to the terminating resistor
7 Connection for remote control 20 Connection for control cable to the wire
feed unit or for the terminating resistor
8 Connection (+) for welding current cable
at SMAW (MMA) welding or for return
cable at TIG (GTAW) welding 21 Connection for gas hose
9 Cooling water filler 22 Connection (+) for welding current cable
to the wire feed unit
10
Connection with ELP
1
for cooling water
to the TIG torch - BLUE
23 Connection (-) for the return cable wire
feeder unit
11 Connection for cooling water from the
TIG torch - RED 24 Connection for cooling water to the wire
feed unit - BLUE
12* *Only on WeldCloud™ version: Antenna 25 Connection for cooling water from the
wire feed unit - RED
13* *Only on WeldCloud™ version: USB
Connectivity
1
) ELP = ESAB Logic Pump, see section "Cooling unit" in this chapter.