- 14 -
hfa9o1ea
4.2
Loading the welding wire
1. Mount the wire drum according to the instructions on page 11.
2. Check that feed roller (
1
) and contact jaw or contact tip (
3
) are of the correct
dimension for the selected wire size.
3. When welding with fine wire:
S
Feed the wire through the fine Wire feed unit (
6
).
Ensure that the straightener is correctly adjusted so that the wire emerges
straight out through the contact jaws or contact tip (
3
).
4. Pull the end of the wire through the straightener (
2
).
S
For a wire diameter greater than 2 mm; straighten out 0.5 m of wire and feed
it by hand down through the straightener.
5. Locate the end of the wire in the feed roller (
1
) groove.
6. Set the wire tension on the feed roller with the knob (
4
).
S
Note!
Do not tension more than is required to achieve an even feed.
7. Feed the wire forward 30 mm below the contact tip by pressing
on the
control box
PEK
.
8. Direct the wire by adjusting the knob (
5
).
S
Always
use a guide tube (
7
) to ensure even feed of fine wire (1.6 - 2.5 mm).
Accessories:
S
Fine-wire straightener (
6
) to be fitted on top of
the clamp of the wire feed unit (
2
).
N.B.
When mounting the fine-wire straightener,
remove the plate (
9
) if it's exists.
N.B.
The protection plate (
8
) shall not be removed
GB
Содержание A6 Mastertrac Tandem
