Assembly
Reference Figure 2
1. Connect plated steel handle (PT20-012) to the
top of the centerpost assemble as seen is Figure 1.
2. Lock the supplied plated steel hex nut (PT20-013) to
secure steel handle
3. Close the air adjustment cap on the regulator assembly
by turning it clockwise.
4. Connect the air hose from your compressor to the air
connection point using a 1/4" NPT coupling and a
minimum 3/8" hose barb. It is not recommended to use
“quick-connect” style fittings, as they will restrict air flow to
the tank & gun.
5. Regulate air source to approximately 50 P.S.I.
PT20-013
PT20-012
Air
Adjustment
Cap
Coupling /
Hose Nipple
(Sold Seperately
)
Figure 2
Operation
Reference Figure 3
1. Unscrew and remove tank cover assembly from the
aluminum cup.
2. Premix gel coat or resin in cup per manufacturers
instructions. Bag liner is optional.
3. Close the air adjustment cap on the regulator assembly
by turning it clockwise.
4. Fill cup to 3/4 full mark shown in Figure 4.
5. Lower and assemble tank cover to aluminum cup.
6. Set compressors regulator to the correct setting.
7. Connect the regulators iar connection to the your air
source hose. Inspect for leaks and re-seal if neccessary.
Figure 3
Tank Cover
Assembly
2 Liter
Aluminum
Cup
Caution:
When the cup contains material, always keep the spray gun upright. This will keep material
from conaminating portions of the spray gun it was not intended to go. Never leave catalyzed
gel coat or resin to remain in the aluminum cup.
Caution:
For thorough cleaning, the cup may be fully immeersed in solvent. Do not leave the cup in
solvent for more than 24 hours. Never immerse your spray gun in solvent. When cleaning, only
brush solvent onto exterior parts only.