6
USER’S MOUNTING INSTRUCTIONS
After the initial set-up assembly is completed use the following procedure to mount the attachment to the loader.
Coupler wedges or pins must extend through holes in attachment. Levers must be fully
down and locked. Failure to secure wedges or pins can allow the attachment to come off and cause injury
or death.
1. Use the step, safety treads, and grab handles to
get on and off the loader and attachment.
2.
Sitting in the operator’s seat, lower the seat bar (if
so equipped) and fasten the seat belt.
3. Drive the loader to the rear of the adapter and put
the loader mounting plate into the adapter mount
bracket.
4. Tilt the loader coupler backward a small amount
until it is fully engaged in the adapter mounting
bracket.
5. Stop the engine and engage the park brake.
6. Secure the coupler locking mechanism that
attaches the attachment to the loader.
7. Drive the loader to the rear of the primary
attachment and put the adapter mount wedge into
the attachment mounting bracket.
8. Tilt the loader coupler back a small amount until
the adapter mount is fully engaged in the
attachment mounting bracket.
9. Stop the engine and engage the park brake.
10. Secure the coupler locking levers that attach the
attachment to the adapter mount.
NOTE:
If the primary attachment being mounted to
the adapter has hoses, follow the hydraulic
connection instructions in the primary attachment’s
operator’s manual.
Mounting is now complete, and the attachment is
ready for operation. Use the reverse order of the
above instructions to dismount the attachment and
adapter mount from the loader.
