9
OPERATING INSTRUCTIONS________________
1. With the operator in the loader seat, seat belt
fastened and seat bar lowered (if so equipped),
start the engine.
To avoid injury or death, do not
allow any person to be directly under the
attachment or load at any time.
To avoid injury or death, never
use Teleboom
on an incline to prevent the
loader from tipping over.
To avoid injury or death, carry
the load as low as possible when moving the
Teleboom.
2. Adjust the manual beam as needed on the ground
and before you hook up to what will be hoisted.
3. Make sure the hair pin keeper is installed on both
the manual beam pin and lift hook pin before
operation.
4. Carry load low and close to the loader while
moving the load into position.
5. When the loader is in position to raise the
material, do so slowly and carefully.
6. Use the loader
’s lift arms first and then the
attachment
cylinder for hoisting to the final desired
position.
To avoid injury or death, be
aware of your surroundings. Contact with
electrical power lines can be fatal. Always use
a spotter to help guide you when moving or
lifting.
To avoid tipping, NEVER exceed maximum load. ALWAYS know load weight before
lifting. Maximum load depends on configuration:
Rated load of attachment:
Full retraction:
750 lbs.
Cylinder extended only:
650 lbs.
Full extension:
350 lbs.
