Bip
A+B
A
Bip
A or B
5 Sec.
Bip
Fig. 5
5 - TRANSMITTERS MEMORIZATION
Bip
A
Fig. 4
P1
Bip
5 Sec.
Bip
6 .
If the memory is full, when you try to memorize a new transmitter the buzzer does 3 bip.
Memory full
7 .
7.1 Single transmitter
1) Push P1 until the bip of the buzzer, then release it.
2) Push the key of the transmitter to delete until the bip of the buzzer.
7.2 Full Memory erasure
1) Push P1 until the bip of the buzzer, then release it;
2) Release P1 and push it again until the buzzer does 3 bip: at this point the memory has been completely erased.
Memory erasure
Bip
A+B
B
Bip
Fig. 6
P1
2 Sec.
1 Sec.
Procedure
1) Keep pushed the button P1 for 4 sec. until the
buzzer makes one bip ( Fig. 3);
At this point it’s possible to set a release delay for the
relay different from 1 Sec. ( by default ): press P1
many times as are the seconds of the delay desired.
( max 30 Sec.).
5 sec. after the last pulse given, the buzzer makes a
bip and the procedure ends.
Bip
Fig. 3
5 Sec.
Bip
P1
Bip
N Sec.(max 30)
P1
Bip
5.1 Using P1
1) Keep P1 pressed down until the buzzer BUZ emits a
short bip ( Fig. 3);
2) Push the key of the transmitter to memorize and
verify the bip of the receiver;
3) At this point the receiver waits for more transmitters
: 5 seconds after the last transmitter memorized the
receiver makes a bip and the procedure ends.
5.2 Without P1
With this procedure it is possible to memorize the
transmitters without accessing to P1 ( Fig. 4).
1) Push simultaneously the keys A + B of the
transmitter until the bip;
2) Release and then keep pushed the key A until the
next bip of the buzzer ( memory opening );
3) Release A and push the key of the transmitter to memorize ( A or B ) until the bip of the buzzer ( memory closing).
NOTE :
The memorization of a new transmitter can be done only by using a transmitter already memorized.
Use the transmitter already memorized to open the memory ( step 1 and 2 ).
Complete the procedure by pressing the key of the new transmitter to memorize.
It’s possible to program the receiver to make a bip at each
relay activation.
Follow the procedure below.
1) Press simultaneously the keys A+B of a transmitter already
memorised.
2) Release and press the key B of the transmitter up to the bip.
For the bip disabling repeat the above procedure
8. Enabling/disabling the activation bip
( Fig. 6)
IS-RNN128ERUK Rev. 1 del 22/4/2020
Manufactured by CDVI Wireless S.p.A.
Via Piave, 23
31020 S.Pietro di Feletto (TV)
Tel: +39-0438-450860 - Fax: +39-0438-455628
Internet: www.erone.com - E-mail: [email protected]
T H E S M A R T L I V I N G
WARRANTY
The warranty period of this product receivers is 24 months, beginning from
the manufacturing date. During this period, if the product doesn’t operate
correctly, due to a defective component, the product will be repaired or
replaced at the sole discretion of the producer. The warranty does not
extend to the receiver case which can be damaged by conditions outside the
control of the producer.
