9
2.4
Waterproof Cable Connector (Outdoor Only)
Follow the instruction below to waterproof the connectors of different types of
cables. The supported cables are as shown below.
All-in-One Cable
IP66 RJ-45 Cable
All-in-One Cable
Follow the steps below to waterproof the connectors of the All-in-One cable.
Step 1:
Connect the required devices to the All-in-
One cable and coat the joints with silicone gel.
There should be no gap between the
connectors and the cables. For the alarm I/O
connector and the power connector, make
sure the side with wires attached is also
sealed with silicone gel.
In addition, attach the ground cable to the
ground and wrap the wires with silicone gel.
Make sure the wires are not exposed to the
air.
Step 2:
Seal the end of the rubber coating of the All-
in-One cable as indicated in the figure on the
right. Please use enough silicone gel to fill in
the hose and wrap around each wire;
otherwise, waterproof function cannot be
guaranteed.
