Erie water treatment pHneutralizer Series, Техническое руководство

Страница: 10 / 29

ELECTRONIC CONTROL PANEL
Page 10
PROGRAMMING INSTRUCTIONS -
PARAMETER SET LEVEL

All configuration parameters on this water filter have
been pre-programmed in the factory, to offer optimal
performance in a wide range of applications and situations.
See table at the end of this manual for default factory
parameter settings. Nevertheless it may be necessary or
desirable to change any of these parameters, to further
optimize the water filters performance or to adapt it to the
specific requirements of the installation.

Before entering the programming mode, make sure that
the control valve is in the service mode.
1.
Press the scroll button and hold it for 5 sec until the
display shows:
2.
Within 10 sec, press the up button; the display will
show:

Press the up or down button to set the length
of the regeneration cycle.

Press the scroll button again to advance to the next
regeneration cycle.
Cycle 1 Backwash
Cycle 2 Purge
3.
Press the scroll button again; the display will show:

Press the up or down button to set the time of
regeneration.
4. Press the scroll button again; the display will show:

Press the up or down button to save the
program into the NOVRAM® and exit the
programming level.
System Check
Cycle 1: 8 min
Regen @ 0:00
Exit