Ericsson MX8400, Справочное руководство

Страница: 159 / 226

Conditional Access
D.4.3 Set Up an EMM Generator
D.4.3.1 Streaming EMMs to Multiple Output Transport Stream
MX8400 Release 5 allows a single EMMG connection providing a single EMM
stream to be distributed to all the required output transport streams.
Note: Refer to the nCC Setup information for further details.
•
The EMM is currently defined in the Service Plan in each output Transport
Stream. This continues to be the case to allow for backward compatibility.
•
The MX8400 identifies EMMs which are unique to one output transport stream.
•
The MX8400 identifies EMMs which are common to multiple output transport
streams.
•
A single EMMG connection is made for those EMMs that are shared across
multiple output streams.
•
Where EMMs are shared across multiple output streams, each stream is
allocated the same EMM bit rate by nCC within the service plan.
•
Where EMMs are shared across multiple output streams, MX8400 output
transport stream isolation applies.
Note: Where EMMs are shared across multiple output transport streams, any
corruption of the EMM input stream affects all output transport streams.
D.4.3.2 EMM/PD Capabilities
•
8 EMMG/PDG TCP/IP connections( Simulcrypt channels) per a MX8400 chassis
(8 shared between EMMG and PDG connections)
•
16 EMM streams per an EMMG/PDG TCP connection.
•
2 Mbps combined of EMM/PD per multiplexer engine.
•
Maximum of 8 Mbps of EMM/PD as measured by the MX8400 in total.
•
TCP control and de TCP control and UDP delivery
•
Single shared EMM TCP port for all connections
•
Single shared EMM UDP port for all connections
D.4.3.3 EMM DVB Simulcrypt Injector Dialog Box: Device Tab
This section describes how to set up an EMMG in nCompass Control.
2/1553-FGC 101 1014 Uen B D-9