Ericsson Monogram Series LBI-39132, Руководство по обслуживанию, Страница: 45 / 110

With a hot-air system, apply hot air until all "tinned" areas are melted and the component is seated in place.
It may be necessary to slightly press the component down on the board. Touch-up the soldered connections
with a standard soldering iron if needed. Do not use excessive solder.
•
CAUTION: Some chemicals may damage the internal and external plastic parts of the radio.
4. Allow the component and the board to cool and then remove all flux from the area using
alcohol or another approved flux remover.
SURFACE MOUNTED INTEGRATED CIRCUIT REPLACEMENT
Soldering and de-soldering techniques of the surface mounted IC’s are similar to the above outlined
procedures for the surface mounted chip components. Use extreme care and observe static precautions
when removing or replacing the defective (or suspect) IC’s. This will prevent any damage to the printed
circuit board or the surrounding circuitry.
The hot-air soldering system is the best method of replacing surface mount IC’s. The IC’s can easily be
removed and installed using the hot-air system. See the manufacturers instructions for complete details on
tip selection and other operating instructions unique to your system.
If a hot-air system is not available, the service technician may wish to clip the pins near the body of the
defective IC and remove it. The pins can then be removed from the PCB with a standard soldering iron and
tweezers, and the new IC installed following the Surface Mount Component Replacement procedures. it
may not be necessary to "tin" all (or any) of the IC pins before the installation process.
VOLTAGE CHARTS
The following pages provide voltage readings that may be used in troubleshooting the radio unit.
MONOGRAM SERIES HANDHELD
COMPONENT REPLACEMENT
Page-41-
Dec.94