Ericsson BDV BS 101 01, Руководство по установке

Страница: 91 / 225

46(48)
Date Rev
Documentnumber Prepared
Doc respons/Approved Checked Reference
1999-07-15
A
1531-BDV BS 101 05 Uen
INSTALLATION INSTRUCTION
Subject responsible
9 MARKING OF CABLES
Each cable that is connected to a PBX type ASB 150
should be marked on the cable’s designation holder
with the label set SVH 277 003/4, supplied for this
purpose. The cable TSR 902 0444/1 is supplied with a
designation holder, 860 1839, at the EURO-connector.
This label set contains three label types:
Label 1: This label indicates the abbreviated name
for the PBA to which the cable is to be
connected.
Example of parameter:
Label 2: There is one 2-digit parameter.
This parameter indicates the position of
the PBA-slot in the PBA where the cable
is to be connected.
Example of parameter:
Label 3 There are two 1-digit parameters.
The first parameter indicates the position
of the pin-contact unit on the PBA.
The second parameter indicates the 1/4
of the pin contact.
Example of parameters:
These three labels indicate where the upper part of the
cable is to be connected and are placed on the front
side of the designation holder.
When the label 1 for PBA has a "_" included in the
name, please enter the correct letter with a marker
pen.
9.1 External MDF SXK 106 4139/1
Unpack the MDF cabinet and remove its front cover.
Mount the MDF cabinet on its designated position.
Take into consideration the normal working height
above the floor (about 1.30 m to the lower edge of the
MDF cabinet) and the length (1.5 m) of prefabricated
cable
TSR 902 0444/1.
Overall dimensions
of the MDF cabinet: 295x184x68 (HxWxD in mm).
0 1 2 3 4
2
4
6
1st
1/4
2nd
1/4
3rd
1/4
4th
1/4
Front side of
designation
holder on cable
to PBA
Label 3:
Position of pin
contact unit
on PBA
BTU_
03
6
*
2
Label 2:
Placing of PBA
in
PBX
Label 1:
Type of PBA
BTU_
03
6
*
2
147 mm
228 mm
Mounting of MDF cabinet
Mark mounting holes for MDF cabinet
Loosen cover only by hand force
1
(there are no holding screws)
2
Drill and insert plugs
3
(Use enclosed screws and plugs)
Mount MDF cabinet and screw it
4
securely into position