Ericsson GE PCS 136-174 MHz, Руководство по техническому обслуживанию

Страница: 16 / 28

FUNCTION PROGRAMMING DESCRIPTION
MONITOR Button
Programmed for Channel Guard
Programmed for Squelch
Momentary Hold Down
DIS/ENABLE CG MONITOR
MONITOR DIS/ENABLE CG
Channel Guard Enable Manual
Auto
Must re-enable CG with MON button after transmitting
PTT will re-enable CG
ANI Front
End
ANI side tone
Delay
Sent at front of message
Sent at end of message
YES/NO: Tells operator when it is OK to talk. (Only
happens when front of message programmed.)
Independent of alert beep.
Delay for repeater to decode Channel Guard.
SCAN SCAN for CG
SCAN for TX channel
YES/NO:
Sel Ch (TX on select channel)
RX Ch (TX on received channel)
SCAN Hang time Time receiver remains locked on channel after carrier
drops (programmable).
Hang after PTT release YES/NO: If Yes, receiver stays on channel for
programmed hang time before SCAN resumes.
Beep on P1 YES/NO: Short beep after receiving P1 call.
(Independent of audio alert beep.)
SCAN Prog Mode Front- all channels programmed from keypad.
Fixed - P1 fixed by PC. Other channels keypad
programmed.
Selected - P1 follows selected channel. Other channels
keypad programmed.
T-99 Alert Beep
Alert Beep VOL
YES/NO: Alert beep rec PG
VOL MAX
DTMF Auto Dial Talk Number
Start Gap
Digit Length
Gap Length Number to be dialed with or without *.
Delay between * and number.
Length of digits.
Gap between length.
Table 1 - PCS Function Guide
LBI-38956
16