888-SV-22DL-00 rev C
2
8
c
To adjust lift tension, turn nut
at bottom of lift. After several
revolutions of nut, test tension by
moving LCD up and down. Con-
tinue adjustment procedure until
LCD can be moved easily up or
down with equal force, but stays in
desired position when released.
d
When adjustment is complete, move RUI back into place.
a
Attach LCD to pivot with provided M4 x 10mm screws or knobs.*
a
Make sure riser is locked (lift brake down), then remove the two
capped screws anchoring the riser to the tower.
b
Save the screws and caps in the provided bag to be used if the
riser needs to be anchored to the tower at a later time.
Attach the pivot to your display.
4
Adjust LCD lift for smooth up and down motion.
To Increase Lift:
Turn adjustment nut
clockwise
several turns - test again and
repeat if necessary.
To Decrease Lift:
Turn adjustment nut
counter
clockwise
several turns - test
again and repeat if necessary.
1
Prepare for cart set-up.
2
Remove anchor screws connecting riser to tower.
riser
tower
3
2
1
• 9/16"
• 3/8" (10mm)
• 3/8" (10mm)
a
a
Gather tools for cart
set-up.
b
To prevent the riser
from moving during
set-up, lock riser by
pushing the lift brake
down.
a
b
b
WARNING:
The riser can move up on its own very
quickly when a counter-balancing force is removed!
Therefore, always lock the riser down with the lift brake
when adding or removing equipment
and
when removing
or inserting the anchor screws which secure the riser to
the tower during shipping. Failure to lock the riser at
such times can result in serious personal injury and
possible damage to cart and/or equipment.
Mounting Equipment
*
Screw attachment deters theft while
Knob attachment allows fast removal
of the LCD without the use of tools.
Products off ering additional security are
available for purchase - visit our website:
www.ergotron.com
a
Hold LCD on both sides and lift up and down - if you feel excessive resistance, or if the LCD doesn't
stay in the desired position when released, adjust for equal lift in both directions.
b
Lower the RUI display by loosening the bracket screws with a screwdriver
for better access to the lift adjustment nut which is located at the
bottom of the 5" lift.
a
b
*
The RUI does not need to be lowered if you prefer
to make the lift tension adjustment with a box wrench
instead of a socket wrench, as illustrated below.
c
d
3/8"
(10mm)
3/8"
(10mm)
Содержание StyleView SV22-92023
Страница 14: ...888 SV 22DL 00 rev C 14...
