Product Specifi cations
The Carts are designed to securely store, transport and charge laptop computers. The LTSC20 has 20 separate storage bays with a
120 V receptacle in each bay. The maximum electrical output for each Cart is rated at 12amps.
The LTSC30 has 30 separate storage bays with a 120 V receptacle in each bay. The maximum electrical output for each Cart is rated
at 12amps.
Before You Use the Storage Cart
• A receptacle shall be installed near the Laptop Storage Cart and shall be easily accessible.
• For your safety have a qualifi ed electrician test the circuit you will be plugging in the unit. The circuit should be
checked for ground integrity to verify that it will handle up to 12A draw and that appropriate branch circuit
protection is in place.
• The Cart’s ground prong must be present for safe operation. If the plug is damaged or if the ground prong has been removed it
should be replaced by a qualifi ed electrician.
• The Storage Cart should only be used for the storage, transport, and charging of laptop computers.
• The use of the Cart including plugging or unplugging laptop computers, plugging or unplugging the Storage Cart, operating the
control switch, engaging or releasing the directional and total lock casters must be done with adult supervision. The Cart can be
very heavy when fully loaded and should be moved by persons physically able to do so.
• The cable ties are provided to secure charging cords to the shelves using the two rectangular cut-outs.
To Charge Your Laptops
1. Locate the external control switch near the bottom of the unit. Move the switch to the middle “OFF” position.
2. Plug in the 12’ power cord for the cart into a suitable receptacle.
3. Push the switch into the down “INSIDE” to direct power inside the enclosure and charge the laptops. External outlets will not
receive power when the switch is in the down position.
To Use the Outside Electrical Receptacles
The storage cart has two 120 V convenience outlets located on the outside of the unit. The maximum electrical output for the
combined external receptacles is 12 A.
1. Locate the external control switch near the bottom of the unit. Move the switch to the middle “OFF” position.
2. Plug in the 12’ power cord for the cart into a suitable receptacle. Plug in your other hardware such as printers and overhead
projectors to use the Cart as a lecture station.
3. Push the external control switch to the up “EXTERNAL” position. You will feel a positive engagement of the switch indicating
power to the external receptacles. In this position the internal receptacles are disabled and no charging to stored computers
will occur.
Loading Your Laptops into the Cart
1. Open a Door by pulling the T-handle out from the recessed area. Turn it clockwise 90 degrees and open.
2. Locate the external control switch near the bottom of the unit on the outside. Push the switch to the middle “OFF”
position. When in the middle position, power is cut off from both internal and external receptacles. To eliminate any arcing, the
switch should be in the off position when devices are being plugged in or removed from the storage bays and prior to plugging the
storage cart into a wall receptacle.
3. Load one laptop into each storage bay. Make sure the power switch is in the middle “OFF” position and then plug them into the
120 V receptacle in each bay. Repeat the loading on other side of the cart if necessary.
3 of 6
300-5229-00 rev. N • 5/17