Ergon Crafco SUPER SHOT 125, Инструкция по эксплуатации и запасным частям

Страница: 78 / 176

Super Shot 125 DC 70CFM EU Part Manual
Chapter 8 Troubleshooting
©2022 by Crafco, Inc. All Rights Reserved
………………………………………………………...Troubleshooting (48300N) 8-2
Step Possible Cause If . . .
8 Is there smoke coming out of the exhaust
stack?
•
Yes, go to Table 8-6 Smoke Coming Out of
Exhaust Stack .
•
No, go to Step 9.
9 Is your burner working properly, but it
seems like it takes a lot longer to reach
operating temperature?
Yes, go to Table 8-11 Sealant is Heating
Slowly .
•
No, Call Crafco, Inc. and speak to a
customer service technician.
Burner Electrical Troubleshooting
Note : Use Fig. 8-1 Diesel Burner Schematic while troubleshooting the burner electrical system.
.
Step Possible Cause If . . .
1 Is there 12Vdc between the
“YEL-CHI-E” and
“BLK” wires at the burner plug?
•
Yes, go to Step 4.
•
No, go to Step 1a.
1a Is there 12Vdc between the
“YEL-CHI-E” wire
on the burner relay in the control box and the
“BLK-2” wire on the relay?
•
Yes, check for poor connection or broken
wire between the burner relay in the control
box and the plug on the burner.
•
No, go to Step 1b.
1b Is there 12Vdc between
“WHT/RED-1” wire
on the burner relay in the control box and the
“BLK-2” wire on the relay?
•
Yes, go to Step 2.
•
No, check for poor connection or broken
wire between the burner relay in the control
box and the burner reset switch.
2 Is there 12Vdc between the circuit breaker
(red wire going to battery positive cable) and
the ground lug on the battery tray?
•
Yes, wait 15 seconds then repeat step 2.
•
If still no voltage then replace circuit
breaker.
•
No, go to step 2a.
2a Check for loose or broken wires between
circuit breaker and battery positive cable.
•
Yes, replace or repair damaged wire and
repeat Step 3.
•
No, go to step 3.
Table 8-2 Basic Visual Troubleshooting (continued)
Table 8-3 Burner Electrical Troubleshooting