ergoline ergoselect 1, Руководство оператора

Страница: 16 / 38

14 ergoselect 1
5 Setup and Mains Connection
5.5 Connecting the Power Cord
• Rotate the handlebar of the ergometer towards the front.
• Tilt the ergometer carefully towards the front until it
rests on the handlebar.
Figure 5 – 5: Assembly position of the ergoselect 1 ergometer
• Connect the power cord on the underside of the
ergoselect 1.
• Insert the power cord into the strain relief and screw
the strain relief to the frame. Make sure that the plastic
pin engages in the corresponding hole.
• Return the ergometer carefully to its upright position
and adjust the handlebar.
• Plug the power cord into a wall outlet.
Figure 5 – 6: Power cord in strain relief mounted to frame
Warning
• Arrange the power cord properly.
• Lay the power cord flat on the floor.
• Keep the power cord away from the pedals.
Caution
Equipment Damage
Before connecting the ergometer to the power
line, check that the line voltage corresponds to the
ratings on the type plate.
The type plate is located on the back of the device, at the bottom.
Note
Disconnection from Power Supply
Pressing the power switch or removing the power
cord disconnects the device from the power supply.
Removing the power cord results in a complete disconnection
of the device from the power supply (all poles).
Ensure that the power plug is readily accessible at all times.