T
he
h
ybrid
K
angaroo
-
aSSeMbLy inSTrUCTionS
Assembly Parts list
A. (10) Black Screw Covers
B. (2) 1/4-20 x 3.50
Hex Head Bolts
C. (1) 5/32 Allen Wrench
D. (2) Fender Washers
E. (2) Acorn Nuts
F. (3) 1/4-20 x 7/8 BHCS
G. (2) Thick Black Washers
H. (1) 7/16 Wrench
I. (2) Locking Star Washers
Step 1:
Lay the lifting assembly on a solid surface with the back side up as shown. Notice the single Button Head
Bolt in the assembly union plate.
DO NOT LOOSEN THE SINGLE BUTTON HEAD BOLT THAT IS NOTATED.
Step 2:
Notice the (2) oversized holes in the Base Plate. The Single Button Head Bolt will go into the oversized hole
on the top right, while the other 3 holes should line up with the base. The center oversized hole is not used with this unit.
Step 3:
With the Base Plate over hanging the table about 2 inches, hold the Lifting As-
sembly above the Base Plate and align the Single Button Bolt into the oversized hole.
Place one 1/4-20 x 7/8 BHCS{F} through the base plate to screw in the lifting assembly.
Step 4:
Insert and thread the other (2) 1/4-20 x 7/8 BHCS{F} through the Base Plate
and into the Lifting Assembly. Once all (3) bolts are threaded in, tighten securely with
the 5/32 allen wrench{C}. Lifting Assembly should be flat against the Base and all three
bolts should look like the picture above.
Step 1
Step 2
Step 3
Step 4
A
B
C
D
E
F
G
I
H
Threads of Spring
Single button
head screw
Oversized Holes
Lifting assembly
should be flat against
the base plate
when tight
Fender
Washer
Locking Star
Washer
1/4-20 x 3.50
Hex Head Bolt
1/4-20 x 3.50
Hex Head Bolt
Locking Star
Washer
STEP
5,6,7
Step 5:
Put (1) Locking Star Washer{I} on each of the 1/4 –20 x 3.50 Hex Head Bolts{B}.
Step 6:
Insert the (2) 1/4-20 x 3.50 Hex Head Bolts{B} through the holes in the Vertical Rail.
Step 7:
Put (1) Fender Washer{D} on each of the 1/4-20 x 3.50 Hex Head
Bolts{B} on the other side of the Vertical Rail.
