ErGear EGSS7, Инструкция по эксплуатации

Страница: 7 / 12

Warning:
Ensure bolts are
secured firml y.
For VESA hole pattern:
3 in. (75mm) x 3 in. (75mm)
4 in. (100mm) x 4 in. (100mm)
2-1 Choose Proper bolts 2-2 Install Monitors to the Arms
1
0.1-0.2in.(3-5mm) spacing left
The tension is preset at
8.8~11 Ibs(4-5kg). After
hanging the monitor to
the mount, please
release the
monitor slowly to
prevent it from falling
suddenly.
100x100mm
75x75mm
A
Screwdriver
[Not Included]
Flat back monitor
Round back monitor
100x100mm
75x75mm
B-1
B-2
Step 3 Adjust Gas Spring Tension
Be sure to keep the arm in
horizontal position during
adjustment. Or else, it would be
difficult to adjust the mount or
damage the mount.
1. If the monitor can stay at the desired height by
itself, no adjustment needed.
2. If the monitor rises up, press the arm to keep it
in horizontal position and then use the 13/64
in.(5mm) Alley key (F) to turn the bolt clockwise(“-”
direction) to reduce tension of the arm only until
the monitor can stay at the desired height by itself.
3. If the monitor falls down, lift the arm to keep it in
horizontal position and then use the 13/64 in.(5mm)
Alley key (F) to turn the bolt counter-clockwise
(“+” direction) to increase tension of the arm only
until the monitor can stay at the desired height by
itself.
Step 2 Attach Monitor to the Arm
02 03 04 05 06 07 08 09 10