Product description
Lower end
position is
readjusted
Press
DOWN + STOP
for 5s
1x run up and
down,
1x signal tone
Move to
requested
end position
Press
DOWN + STOP
for 2s
2x runs up and
down,
3x signal tones
Electric accessories – Programming instructions | EN
Subject to technical change. 07 / 2022
Overview
Name:
Battery motor EAM25
Torque:
1,1 Nm
Speed:
28 rpm
Voltage:
5 V
Connexion: USB-C
Performance:
1,2 A
Radio frequency:
433,925 MHz
Capacity:
2200 mAh
Temperature range: 0°C bis 50° Celsius
Protection class:
IP20
Conformiy:
Up
Stop
Down
1 channel
15 channel
Back
Up
Stop
Down
Channel
selection
Programming
button P2
Note
• eACCU-wireless-drives must be protected against shocks during transport,
storage and installation. Damaged components must be replaced.
• Please charge the battery full before the first use or when the signal tone indica-
tes low battery! Charging time approx. 6 hours. The LED on the charger lights up
green during charging and green when fully charged.
• Use the original chargers of the EAM-series for charging.
• The programming of the channels as well as the end positions are permanently
stored and remain even when the Akku is completely discharged.
• The radio range is up to approx. 20 m in closed rooms.
• A minimum distance of 20 cm must be respected to avoid interferences when
using eACCU-wireless drives.
CR2450
Programming button P1
Charging socket USB-C
Antenna cable
(do
not
cut it off)
http://bit.ly/eACCU-Bedienungsanleitungen
Wireless tubular motor EAM25
Programming instructions
A
Fine adjustment of the end positions
Fine adjustement of upper end position
Fine adjustement of lower end position
ATTENTION!
Motor moves to continuous operation after longer keystroke! Urgently stop
before reaching the end position and then proceed through a tip.
You will receive a preconfigured sun protection product with preconfigured end positions.
Upper end
position is
readjusted
Press
UP + STOP
for 5s
1x run up and
down,
1x signal tone
Move to
requested
end position
Press
UP + STOP
for 2s
2x runs up and
down,
3x signal tones
Programming videos
Watch online:
04046046536116
After use, separate the system, motor and (rechargeable) batteries and dispose the parts separa-
tely. Due to the obligations resulting from the WEEE directive of the EU, erfal, as a manufacturer or
distributor of electrical and electronic devices, takes back freely controls, drives, other electrical accessories,
old batteries and accumulators. Contact your seller for the exact procedure. End users are legally obliged to
delete personal data on old devices before disposal. Further, it should always takes place in the discharged
state and secured against short circuits.
MAKE YOUR CONTRIBUTION TO ENVIRONMENTALLY FRIENDLY RECYCLING.
Remove the cover cap
(only for roller blind with
cassettes)