1. Push the threads
(G)
into the headboard and footboard as shown below.
Tighten the threads by hand ensuring that there is approximately half of the threads still showing.
Step by step assembly instructions
2. Making sure the holes in the side rails (C) are facing upwards, AND that you have the Left and Right rails, (see
page 2) on the correct sides, locate the side rails onto the protruding threads on the headboard and foot
board. As you do this, slide a half moon washer onto the thread when it comes through into the circular
hole in the side of the rail, then screw on one of the 8 nuts
FINGER TIGHT ONLY.
Repeat with the other 3
corners. then
TIGHTEN FIRMLY WHEN ALL FOUR CORNERS ARE SECURED
.
Using the
(M)
12 x 25mm screws
, attach the two brackets (J) into the headboard and the footboard using the
pre-drilled holes, tighten with a phillips screwdriver.